8Kw stove manufactured in our own factory in Hereford from 3mm (1/8) plate fully welded. Works out at around same cost of three large bottles of propane. They also have a good resale value. They are top loading and have no ash tray to avoid ash spillage. Emptying is needed every 3/4 weeks.The slide vent on the top of the stove regulates air down an internal tube to the base of the stove enabling lighting from even fine sawdust or wood chippings and set on a minimum draft it is possible for the fire to stay in overnight. To light the stove you simply wrap a newspaper around a 75mm square section of wood approximately 600mm long and place this in front of the down pipe prior to loading and compacting the shavings/sawdust. When filled you simply remove the timber leaving the newspaper behind and light at the base and replace the lid. The secondary slider adjusts the top draft to help burn the smoke at the top of the stove as this is combustible. The stoves are all cut on our automatic cnc plasma cutting machine and hydraulically folded prior to welding. This modern equipment makes it possible to manufactured a reasonable cost. Each stove is quite heavy. The chimney flue (not supplied) has to be 100 /4 approximately inside diameter and simply sits into the spigot on the top of the stove. The top loading lid has a separate handle so that this stays cold when needed.
To make out of hours arrangements tel. When ordering for the couriers. Stove dimensions inc spigot : 675mm H 380mm W 460mm L. I have added some pictures of a stoves in use.One is of an old stove (around five years) and one of a newly installed stove with a 150mm chimney. The item "Workshop heater burns sawdust, wood and wood shavings. 8Kw" is in sale since Tuesday, October 18, 2011. This item is in the category "Business, Office & Industrial\CNC, Metalworking & Manufacturing\Woodworking Supplies\Other Woodworking Supplies". The seller is "balsawood*123" and is located in Unit 15, Rockfield Road,, Herefordshire. This item can be shipped to United Kingdom.