Short circuit and overload protection Voltage and current indicator With automatic and foot switch heating Built-in pump Heating can up to 1700°, But heating time :Material weight, on-site temperature related Dimension: 330140210mm. Product List 1 host 1 copper ring 1 cooling cylinder 1 foot switch 1 quartz crucible 1 graphite crucible 1 pliers. Model Nominal power Maximum power Ultimate power ZDBT-6 2000W 2800W 3500W How to use: 1, tighten the copper coil, adjust the direction 2, pour 3/4 clean water into the cooling tank, connect the pipe to the main machine and stainless steel water tank 3.Connect the power supply, turn on the switch, check whether it is leaking after pumping water. (If the water leaks, turn off the power then tighten with a wrench) 4. Put the crucible into the copper coil, turn on the automatic switch or turn the foot switch on and heat. Note: After using the machine, Remove the crucible, then power off. After the heating is completed, remove the crucible and the heated object, Discharge the water inside the copper pipe, turn off the power. Note; when use it, the indicator will light up for a few seconds and then go out normally. If there is an overload or a short circuit of the copper coil, the overload indicator light will light up until the problem is solved. This item is in the category "Crafts\More Crafts\Metalworking/ Metal Crafts". The seller is "sofomall" and is located in this country: CN.
This item can be shipped to United Kingdom.