ROXBP1220X1.2 48 X 1.2mm Capacity Box & Pan Folder. A full 1220mm (48) trade duty box and pan folder. An indispensable piece of equipment in any serious fabrication shop and used to make boxes, trays and reverse bends not possible with a straight folder. This is achieved by selecting various fingers that fit inside your desired bend and removing the others to allow the sides of your box to pass either side of the upper beam fingers.The ROXBP1220X1.2 48 X 1.2mm Capacity Box & Pan Folder is wide enough to take full width 4ft sheets and equipped with a heavyweight trussed upper beam and bed to prevent flex and ensure an even, accurate bend over the full sheet width. It will handle full width 1.2mm mild steel bends or 2.0mm aluminium.
The 16 removable fingers are precision machined from hardened steel and the bed and beam are adjustable for alignment fore and aft and fitted with 2 independent cam action levers to raise the beam well above the bed. Maximum depth of tray is 40mm bending with material outside or 20mm with material inside.
16 Tip hardened steel box fingers Left and right beam control levers Bends from 0 degrees - 135 degrees Fully trussed for strength and precision Box finger sizes: 50mm x 5, 75mm x 6, 100mm x 5. 50mm (5), 75mm (6), 100mm (5). The item "Roxxtek 48 X 1.2mm Capacity Box and Pan Folder" is in sale since Friday, February 02, 2018.This item is in the category "Business, Office & Industrial\Metalworking/Milling/Welding\Folders". The seller is "stakesys" and is located in Loughborough. This item can be shipped worldwide.